Autopage AP4000EX Manuale di istruzioni per l'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Allarme auto Autopage AP4000EX. Autopage AP4000EX 17. Access point
Anche per Autopage AP4000EX: Manuale di funzionamento e installazione (15 pagine)

Stampa la pagina

LED & TONE IDENTIFICATION

1. Zone LED

RED/GREEN alternate flashing LED with 2 short beeps = Vehicle security has been breached.

RED flashing LED with 1 long beep = Added sensor or sensors have been triggered,

GREEN flashing LED with phone type ring = Pager call button has been activated.

2. Identification LED

RED flashing LED = Trigger alert from vehicle #2 (*)

GREEN flashing LED = Trigger alert from vehicle #3 (*)

(*) Requires optional paging transmitters in each vehicle.

(INSERT PICTURE OF PAGER SHOWING LOCATION OF LED'S, ON/OFF SWITCH, AND RESET

SWITCH)

PAGER MEMORY

The AP4000DX pager will recall the last trigger or call input signal in its memory while

in the stand-by mode. To recall the memory, press the reset button. The LED will flash as noted above in the LED and

tone identification section. If in the vibration mode, the pager will vibrate every 30 seconds to indicate it has received a

trigger or call signal. If in the tone mode, the pager will beep 1 time every 30 seconds to indicate that it has received a

trigger or call signal.

NOTE: Turning the pager off will automatically clear the memory.

USING THE CALL BUTTON

The driver of the vehicle may wish to send a call signal to a passenger outside the vehicle who is carrying the pager. To

send a call signal, press the call button located in the vehicle.

NOTE: The call button will function with the vehicle ignition on or off.