Autopage RF-410 Manuale operativo - Pagina 4

Sfoglia online o scarica il pdf Manuale operativo per Allarme auto Autopage RF-410. Autopage RF-410 8. Professional vehicle security system

Stampa la pagina

1. Transmitter Operation

PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case of

emergency.

Press and hold the

sound.

During panic mode, the normal function of this transmitter button will be suspended. The

and

buttons can be used to lock and unlock the doors (if the option is installed),

however once the

installed) will be enable allowing the vehicle to start.

To stop the alarm, press and hold the

seconds. Also if the

off immediately.

If the button is not pressed, the alarm will automatically stop after 30 seconds.

TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:

1. Light impacts will trigger the warn-away signal. A long chirp from siren/horn.

2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition switch- All

will trigger the programmed sequence.

The starter disable relay (if installed) prevents the vehicle's starter from cranking. The siren and

parking lights will turn on to alert of an intrusion for 30 seconds. Then the siren will stop and

automatically reset and re-arm. If any the sensors or detectors are still active, the alarm system

will sound a maximum of three-60 sec ond cycles.

IGNITION CONTROL DOOR LOCKS. (See Feature II – 3 Programming.).

If the vehicle's door locks have been interfaced to the security system, the system will

automatically lock the vehicle's doors when the ignition is turned "ON" and /or unlock the

vehicle's doors when the ignition is turned "OFF".

TRUNK RELEASE. (See Feature III – 1 Programming.).

Press and hold

button on transmitter for two seconds to remote control the trunk release

or other electric devices.

CAR LOCATOR

Under Armed mode, press the

The siren will chirp 6 times. The parking light will flash 12 times, for you to easily locate

your car.

DOME LIGHT CONVENIENCE DEL AY & SUPERVISION

The alarm with a unique feature which will turn on your vehicle dome light as following:

Upon disarming, the interior lights will remain on for 30 seconds.

If the vehicle is intruded, the interior light will flash for the same duration as the siren.

Note: Turn ON the ignition switch or arm the alarm will turn off the dome light.

CHANNEL 3 TIMER CONTROL OUTPUT (See Alarm Feature III – 2 Programming.)

Press the

button on the transmitter to active Channel 3 function. (Factory Default )

Press the

button on the transmitter to active Channel 3 function.

(If you Program

button = Channel 3 Function)

Channel 3 is user-programmable timer output. You may program the built-in timer to send a

ground signal for any time interval between 1 second and 2 minutes. For instance, this timer

output may be used to turn on the headlight, power window or sunroof.

Note: Factory default setting at momentary output.

button on the transmitter for 3 seconds. The alarm will immediately

button is pressed, the vehicle's starter disable device, (where

button is pressed and released, the panic mode will be turned

button on the transmitter to active car locator function.

button on the transmitter for 3