Galene GS Series Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Distributore d'acqua Galene GS Series. Galene GS Series 17. Whole house water filter

OPERATION AND MAINTENANCE MANUAL

WATER FILTRATION SYSTEM

o Assemble the support bracket onto the cartridge filter (B) (blue canister).

o Position the cartridge filter (B) and the Softener filter (A) (big cylindrical

vessel) beside each other, in a way the PVC lines match, following the

system layout shown in Figure 2 or Figure 3.

o Connect item #3R /4L (Right or Left installation)to the back of the 5000SE

valve (see Figure 1) on the Softener filter (A) using the connection pins.

Make sure you insert firmly before attempting to insert the pins.

o Screw cartridge filter (B) support bracket onto the wall (screws not

included).

o Proceed to connect items #1 through #6 in order, following the above

system layout, strapping the pipe (item #6-R/#2-L) to the wall using the wall

mounts included. Make sure you initially support the cartridge filter

minimizing any weight or pressure onto the connecting pipes.

Note: It is important to assure your pipes are completely aligned prior to

closing the threaded unions, otherwise you will not have a good seal, and

will create leakage. Make sure you do not overtight the union with a

wrench. This can break the union, and will require to replace the piece.

For best results and to minimize risk of leakage, apply silicon ointment

(such as Dupont Molykote, 111 Compound) on the union gasket prior to

threading closed the union.

o Brine tank (C) should be placed near the softener filter (A), and be

accessible for easy filling access of salt as required. Overflow line on top

side of brine tank should be routed to your house drain, assuring any case

of spill is drained out without causing damage. The black flexible pipe

connected to the right side of the 5000SE valve (see Figure 1), should be

introduced to the brine tank through the white hole, making sure it is

connected to the down pipe located inside the white pipe fixed to the inner

part of the brine tank.

o In case a UV disinfection system (D) is purchased, PVC fittings from

installation kit item #5-R or item #6-L will be replaced with item #5A, #5B or

item #6A, #6B respectively.

o Mount the UV light (D) to the wall with the two wall mounting saddles

included.

Note: Be careful when working with the UV light as bulb is VERY fragile

and may break.