High Tech Pet Power Pet PX-1 Manuale di installazione e istruzioni per l'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Prodotto per la cura degli animali domestici High Tech Pet Power Pet PX-1. High Tech Pet Power Pet PX-1 13. Fully automatic pet door
Stampa la pagina
IMPORTANT INSTALLATION NOTES:
a) When installing the inside mounting screws, make sure they are only moderately tight. Over tightening will
cause your Power Pet door housing to conform to any irregularities in the flatness of your door or wall and will
cause the door panel to slow, stick or malfunction. Just tighten the screws until they stop. That is enough to insure
that the installation is secure. Should your door panel malfunction during the initial power up, loosen each mounting
screw and re-test.
b) Note that screw covers (not pictured) are provided to finish the screw holes. Once installed, the inside screw covers
may be removed by twisting CLOCKWISE using a coin or flat head screwdriver. Twisting counter-clockwise will cause
the screw covers to break.
Initial Power up
Plug the AC Adaptor into a nearby 110 VAC wall outlet. Plug adaptor cord into the left or right Power Input Jack on the
inside frame. (see page 3)
Press the front panel ON button to power up the door. Verify the AC light is illuminated.
Press the manual OPEN button and verify the door panel opens and closes by itself.
Battery Installation
To install the battery, open the battery compartment, and align the two battery lugs with the two lug sockets on the inner
wall of the battery compartment. Then press the battery to mate it to the sockets. When done the battery should be flush
with the wall, and the compartment cover should fit comfortably over the installed battery.
An installed battery is automatically charged whenever the AC Adaptor is powering the door.
Battery Status Indicators
The OK light is illuminated when the battery is more than one-third charged.
The LOW light illuminates when the battery is less than one-third charged.
Note that during door opening these indicators may reverse for a few seconds when the battery is below one-half charge.
This is normal and gives a little advance notice of an impending low battery.
______________________________________________________________________________________________________________________________________
6
AC and Battery Operation
(In Battery Back Up Mode the
Door Automatically Switches
to Battery if AC Power Is Lost.)
Manual Open Button
Automatic Battery
Power Monitoring
Dual Range Controls
For Independant Control of
Inside and Outside Distance
4 Way Access Control
In and Out
In Only
Out Only
Closed
www.hightechpet.com
High Tech Pet Products, Inc.