High Torque Hughes 500 Istruzioni per la costruzione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per la costruzione per Giocattolo High Torque Hughes 500. High Torque Hughes 500 4.

Positions for

balsa & magnets

Prepare the front mounting section by fixing 5 of the magnets

provided, in the positions shown, two on the RH side, two on the LH

side, one in the lower centre, utilize small balsa pieces to mount the

magnets. Rough the faces of the magnets before glueing.

Align the mounting piece with the fuselage and mark the points at

which the internal magnets are to be fixed.

Glue in place the internal magnets on their balsa mounts.

When the glue is dry, allow the mounting section to jump into place

on the magnets. Now the front window can be glued in place. This

should be done from the inside with the mounting section in place

to avoid any distortion. When dry, remove the front section and

glue the side windows in place.

Cut out the parts for the vertical stabiliser, and a section of balsa to

reinforce the fin, fit it between the two pieces, glue together.

Cut the horizontal tail fin and the small vertical fins from balsa, and

assemble all of these pieces together with superglue.

The completed tail fin unit can be mounted in its original place on

the tail tube, using the original screw.

The tail rotor gearbox frame should be cut out at the point shown

this will allow for easier assembly of the drive belt.

H001 Page 3 of 4