High-End Technology F-20 Manuale di montaggio - Pagina 3

Sfoglia online o scarica il pdf Manuale di montaggio per Giocattolo High-End Technology F-20. High-End Technology F-20 18.

Introduction

Although the F-20 goes together very easily, there is still some construction involved, this is NOT a plane for

beginners, and you should have some experience with putting together ARFs. Please look carefully at the

pictures and explanations carefully before performing any work. There are many ways to build a plane, eg servo

mounting methods, it is up to the builder to fully test their airplane and flight controls before flight. As the

builder of the prototype airframe, I like to make servos serviceable as much as possible. Before you glue

anything to any surface, make sure it is clean and in the case of fiberglass parts, I sand first with 80 grit

sandpaper and then clean the area where glue will be applied. I often glue servos to surfaces, I make sure to use

tape around the servo so that when the servo is moved, you can also remove the glue by removing the tape. Try

to use a Single piece of tape around the servo as to provide more strength.

You will require some additional items before you can complete your F-20 constructions, along with some

common model building tools. The amount of channels required is a minimum of 6, but you have to be able to

mix and reverse channels, it is highly recommended that you have more than 6, the prototype model used a total

of 7, as follows: 1channles for flaps, 2 channel for elevators, 1 channel Rudder and otherwise you will

cable for Steering servo (I used a separate channel for steering), 1 channel retracts, 1 channel throttle

Additional Items Required

- HET-RC EDF9305 or similar

- Typhoon EDF motors 700-68-1400 or suitable for your power requirements

- HET-100HV

- 8 micro digital servos (2X Aileron, 2X Elevator, 2X Flaps, 1 Rudder and 1 Steering)

- Retracts

-8 ch. Computer Radio system w/ 8 servos.

-6

- Lipo battery (Suitable for your motor and ESC)

-5 or 30 minute epoxy

-micro balloons

-CA Glue w/ accelerator

-Velcro.

Standard Model airplane building tools:

-Drill or Dremel tool

-Pliers/cutter

-Scissor

-Xacto Knife