High-End Technology F16 Manuale di istruzioni per il montaggio - Pagina 12
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Giocattolo High-End Technology F16. High-End Technology F16 18. High-end technology f16 for electric ducted fan
Stampa la paginaBehind the joint a plywood block is glued in the fuselage. No drill a 2 mm hole
approximately 25 mm behind the joint, this hole is for the bungee hook.
Glue the bungee hook in the fuselage with 5 minute epoxy
Vertical fin installation.
Trial fit the vertical fin first, May you need to sand some from the front of the notch to
get a better fit.
Before you glue the vertical fin in place you can cut 1 or tow holes in top of the notch,
see above picture. Also sand the inside area of the fin and sand the outside of the
notch a little bit. When you heat up the bottom end of the fin with a hair dryer (blower)
the glass-fibre will soften up a little. Now mix 5 minute epoxy with micro balloons and
apply a small ridge mixed glue along the inside edge of the vertical fin.
When you have softened up the bottom sides of the Fin you can press the fin in place
Remove the excess glue with a clean cloth and cleaning alcohol. Make sure the Fin
is aligned and straight up. Keep the edges of the fin pressed against the fuselage
with your fingers or use 2 wooden strips until the epoxy hardens.