Autoplugin GSM Kit-V2 Manuale di installazione - Pagina 10
Sfoglia online o scarica il pdf Manuale di installazione per Elettronica per autoveicoli Autoplugin GSM Kit-V2. Autoplugin GSM Kit-V2 12.
Stampa la pagina5
Unsuccessful
start
6
Operation
cycle too
short
8
CAN-bus
error
9
Settings error Settings have been
11
Heater no
connection
The outer bi-color (red/green) LED can be connected to the GSM-module to
control its status in the case of permanent connection. If Plug-n-Play cable is used
for connection, green status LED of GSM module is placed inside the housing of
OBD-II connector of Plug-n-Play cable and stays visible from the driver's side.
Indication of GSM-module presented in the table 4.
Number
GSM module
of flashes
condition
in series
No SIM access 1. Check for presence of SIM in GSM module
1
No service
2
3
GSM module
is not
initialized
4
Ready
10
The heater was switched
off spontaneously at a
startup
The heater was switched
off spontaneously
There is a problem with
connection of the
module to the CAN-bus
incorrectly stored in
RCP memory
The heater is unplugged
from CAN-bus or is out
of order
User actions required
2. Check that SIM installed correctly
3. Install SIM into a phone and disable PIN
request
1. Check balance of GSM module
2. Check that GSM module is available in GSM
network: make a call to the number of GSM
module and wait for "busy" signal
Refer to the User Manual
Not required
Make a diagnostics of the
heater if the error is repeated
Make a diagnostics of the
heater if the error is repeated
Check for the module's
connection
Reset the settings (8.1.1),
readjust RCP
Make a diagnostics of the
heater
Table 4. Indication of GSM module