Dynasty Fireplaces EF57US Istruzioni per l'installazione e manuale operativo del proprietario della casa - Pagina 7

Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale operativo del proprietario della casa per Riscaldatore elettrico Dynasty Fireplaces EF57US. Dynasty Fireplaces EF57US 9. Electric heater with remote control

WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER!
Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning
your heater.
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping
wet) using a solution of mild detergent and water. Dry the case thoroughly before operating the
heater.
Caution: Do not allow water to run into the interior of the heater as this could create a fire or
electric shock hazard.
The fan motor is factory lubricated for life and will not require further lubrication.
Store heater in a clean dry place when not in use.
Warning: Any other servicing needed must be performed by an authorized service representative.
Do not attempt to service the unit yourself.
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected
to an earthed electrical outlet, turn on the main power switch located on the left hand side of the
appliance. A beep should be heard when the power is first applied.
CAUTION! The unit's power cord must be connected to a properly grounded and protected
120V outlet. Always use ground fault protection where required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the
unit is damaged, please call a qualified service technician to inspect and to replace any part
of the electrical system If necessary.
NOTE! To use both remote and manual function. As the main power switch must be in "ON" position.
Operating by Manual Button
NOTE! The manual button on the fireplace unit is not provide you with all function control, and its
propose is to control some basic function when you lose the remote handset. Please use the remote
handset to carry out all functions.
Main power switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the
"ON" position for any of the functions including the remote to work.

MAINTENANCE

OPERATING INSTRUCTION
main power switch
FLAME
HEATER
heater button
flame button