Autoplugin RCP-FM Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Moduli GSM/GPRS Autoplugin RCP-FM. Autoplugin RCP-FM 12.

Stampa la pagina

Battery low

Time limits

exceeded

Unsuccess-

ful start

Operation

cycle too

short

CAN-bus

error

Settings

error

Heater no

connection

Glossary

CAN - Control Area Network (digital network for data transfer in vehicles)

RCP - Remote Control Plug-in (electronic module for the heater remote control)

CIP - Combined Instrument Panel

BHM or Boost Heat Mode – operational mode of the heater, when it operates

together with the engine to help the engine and the interior warm up more

quickly.

The module has

determined that battery

voltage at heater startup

or during heater

operation is below of

specified by settings 4.1

or 4.2

Time limit for

autonomous operation of

the heater has achieved

(with active setting 2.1.2

- 2.1.9)

The heater switched off

spontaneously at startup

The heater was switched

off spontaneously with

operating time of less

than 20 minutes

There is a problem with

connection of the

module to the CAN-bus

Settings have been

incorrectly stored in

RCP memory

The heater is unplugged

from CAN-bus or is out

of order

Charge battery with special

charger (or start engine to

charge) or cancel 4.1/4.2

module's settings

Run the engine. It is

recommended to make trips

between heater operation cycles

longer than heater operation

cycles

Make diagnostics of the heater

if the error appears again

Make diagnostics of the heater

if the error appears again

Check for the module's cables

connection

Reset the settings (8.1.1),

readjust RCP

Make diagnostics of the heater