DCN S5750E-28X-P-SI Manuale - Pagina 14

Sfoglia online o scarica il pdf Manuale per Interruttore DCN S5750E-28X-P-SI. DCN S5750E-28X-P-SI 19.

S5750E-16(28)(52)F(C)(X)(-P)-SI(R2.0)

The dimensions of the S5750E-16(28)(52)F(C)(X)(-P)-SI(R2.0) series is designed to

be mounted on a standard 19'' rack, please ensure good ventilation for the rack.



Every device in the rack will generate heat during operation, therefore vent and fans

must be provided for an enclosed rack, and devices should not be stacked closely.



When mounting devices in an open rack, care should be taken to prevent the rack

frame from obstructing the switch ventilation openings. Be sure to check the

positioning of the switch after installation to avoid the aforementioned.

Caution！

If a standard 19'' rack is not available, the S5750E-16(28)(52)F(C)(X)(-P)-SI(R2.0)

series can be placed on a clean level desktop, leave a clearance of 100mm around the

switch for ventilation, and do not place anything on top of the switch.

2.1.2 Installation Notice



Read through the installation instruction carefully before operating on the system.

Make sure the installation materials and tools are prepared. And make sure the

installation site is well prepared.



During the installation, users must use the brackets and screws provided in the

accessory kit. Users should use the proper tools to perform the installation. Users

should always wear antistatic uniform and ESD wrist straps. Users should use

standard cables and connecters.



After the installation, users should clean the site. Before powering on the switch,

users should ensure the switch is well grounded. Users should maintain the switch

regularly to extend the lifespan of the switch.

Class A ITE is a category of all other ITE which satisfies the class A ITE limits but not

the class B ITE limits. The following warning shall be included in the instructions for use:

This is class A product. In a domestic environment this product may cause radio

interference in which case the user may be required to take adequate measures.



When using SFP transceiver, do not stare directly at the fiber bore when the switch is

in operation. Otherwise the laser may hurt your eyes.

Chapter 2 Hardware Installation

Warning

2-4