Dynatech V-5000 Istruzioni per l'utente - Pagina 9

Sfoglia online o scarica il pdf Istruzioni per l'utente per Amplificatore Dynatech V-5000. Dynatech V-5000 16. Professional

Stampa la pagina

SPEAKON ASSEMBLY: Y ou will need a pair of Neutrik Speakon

connectors. Y ou will also need high-quality two or four conductor speaker

cable, a pair of needle-nosed pliers and a 1.5-mm Allen key to assemble the

Speakon connectors to your speaker wire. T o assemble the Neutrik Speakon

NL4FC connector, complete the following steps:

1. Strip back 3/4-inch of the cable casing. Strip off 1/4-inch from the end of

each of the conductors down to bare wire, and insert the brass fittings. See

diagram 9.

2. Slide the cable tension clip (D) and the speakon coupler (E) through the

cable end. See diagram 10.

3. Insert each wire with the brass fittings into the top of appropriate slot of the

connector insert (B) as shown in diagrams 10 and 11. Use a 1.5-mm Allen key

to tighten the connection. See diagram 11.

4. Be sure to properly match the positive (+) and negative (–) leads of each

wire. See diagram 12.

5. Slide the connector insert (B) into the connector housing (A), making sure

that the large notch on the outer edge of the insert lines up with the large

groove on the inside of the connector housing. The insert should slide easily

through the housing and out the other side until it extends approximately 3

/4-inch from the end of the housing.

6. Slide the cable tension clip (D) along the cable and insert into the housing

(A), making sure that the large notch lines up with the large groove on the

inside of the connector housing (A). The cable tension clip (D) should slide

easily into the housing until only 3 /8-inch of the cable tension clip (D) extends

from the back end of the connector.

7. Slide the coupler (E) along the cable and screw it onto the end of the

housing (A). Before tightening, you may want to test the connector to make

sure it has been assembled properly.

NL4FC

Diagram 9

Brass Inserts

Diagram 10

Diagram 11

Diagram 12

-1

page 9

4-Conductor Speaker Cable

�

� � � � ��

CAUTION

SPEAKON

1+ HOT

1 COLD

MINIMUM LOAD IMPEDANCE 2 OHM PERCHANNEL 4 OHM BRIDGE

� ��

� � � � � �

�

��

�

-1

� � � � �

� � � � � � � �