COPLAR LTA-LG-01 Manuale dell'operatore - Pagina 10

Sfoglia online o scarica il pdf Manuale dell'operatore per Trimmer COPLAR LTA-LG-01. COPLAR LTA-LG-01 11. Line trimmer attachment

WARNING:

Use only original manufacturer's replacement parts, accessories and attachments. Failure to do so may cause

poor performance, possible injury and may void your warranty.

You may make adjustments and repairs described in the maintenance section. For other repairs, have the

unit serviced by an authorized servicing dealer.

SPOOL REPLACEMENT LINE TAP ADVANCE SYSTEM

NEW PREWOUND SPOOL

See Figures 7 and 8.

If replacing string only, refer to "String Replacement " later in this manual.

Use only .080 in (2.0 mm) diameter monofilament string.

Use the manufacturer's replacement parks for best performance.

1 Stop the engine, disconnect the spark plug wire or disconnect from the power supply. Hold the string

head and unscrew the spool retainer. Turn clockwise.

2 Remove the empty spool from the string head. Use the spring from the empty spool if one is not

ovided with the new spool and string.

3 To install the new spool, make sure the two strings are captured in the slots opposite each other on

the new spool. Make sure the ends of each string are extended approximately 6 in. (152 mm) beyond

each slot.

4 Thread the strings into the eyelets in the sting head. Carefully push the spool the spool into the string

head (gently pull the strings to the outside if necessary). When the spool is positioned in the string

head, grasp the strings and pull sharply to release them from the slots in the spool.

5 Push down and turn the spool counterclockwise until it no longer turns. Hold the spool down and

rotate clockwise a small amount. Release the spool. The spool should be locked down in string head.

If not, hold down and rotate until locked.

6 Make sure the string head and the spool retainer are installed o the shaft by turning the retainer

counterclockwise to tighten.

7 Pull the strings again to rotate the spool into cutting position. Push the spool retainer down while

pulling on string(s) to manually advance the string and to check for proper assembly of the string

head.

STRING REPLACEMENT

See Figures 9, 10, 11, and 12.

1 Stop the engine, disconnect the spark plug wire or disconnect from the power supply. Hold the string

head and unscrew the spool from the string head.

2 Remove the spool from the string head.

NOTE: Keep the spring attached to the spool. Remove any old string remaining on the spool.

3 Cut two pieces of string, each being approximately 9 ft. (2.7 m ) long.

4 Insert the first string into the anchor hole the upper part of the spool. Wind the first string around the

upper part of the spool counterclockwise, as shown by the arrows on the spool. Place string in the

slot on upper spool flange, leaving about 6 in. (152 mm ) extended beyond the slot. Do not overfill.

After winding the string, there should be at least 1/4 in. (6 mm) between the wound string and the

outside edge of the spool.

5 Repeat above step with second string, using the bottom part of spool. Do not overfill.

6 Replace the spool and the spool retainer. Refer to "Spool Replacement" earlier in this manual.

- 10 -

AINTENANCE