Dynaudio Special Forty Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Dynaudio Special Forty. Dynaudio Special Forty 17.

Stampa la pagina

Owner's Manual Special Forty

Fig. 1 Binding posts at rear of cabinet (example).

Connecting

1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of

the cabinet (see Fig. 1). The high quality, gold plated binding posts can accommodate

different connection systems:

4.0 mm banana plugs:

put directly into the binding post without

any tightening necessary.

Cable spades:

posts, insert the spade into the opening,

and secure the spade by tightening the

posts.

Note

• With every connection system, ensure that the contact is tight and has a

proper contact area.

• Connectors with similar gold plating as binding posts will typically offer the

best results and remain corrosion-free.

• Please ensure that the positive and negative cables do not make contact with

each other. Tighten the posts, and check the contact after a few days to make

sure that it hasn't loosened.

P16

The pins can be

Bare wires:

Un-tighten the binding

posts and place the cable into the

binding posts. Tighten the posts.

Un-tighten the binding

Fig. 2 Amplifier loudspeaker outputs (example).

2. Connect the other cable ends to the

Bi-wiring/bi-amping

loudspeaker outputs of your switched off

Dynaudio loudspeakers feature a

power amp (see Fig. 2).

carefully fine-tuned cross-over, optimized

using selected parts and an advanced

circuitry to achieve a truly balanced and

Note

smooth frequency response. Therefore,

Please make sure that the red

dividing the frequency sections through

marked post of the speaker is

bi-wiring or bi-amping is neither

connected to the red marked

beneficial nor optional.

output of the amp, and the white or

black marked post to the white or

Choice of loudspeaker cable

black marked output accordingly.

The loudspeaker cable can have an

impact on sound quality. In general,

quality cable products will yield a quality

result.

Dynaudio loudspeakers are designed

to be very neutral and thus are not

extremely suited to any particular type

of cable. The choice of cable is as much

a factor of matching the cable to the

SPEAKERS

entire audio system. Please consult your

Dynaudio dealer for information about

compatible loudspeaker cables that

will suit both your electronics and your

Dynaudio loudspeakers.

Connecting surround speakers

When connecting a two-channel stereo

system, only the right and left channels

are connected to the amplifier.

In a surround set-up, center, side or rear

loudspeakers as well as a subwoofer are

typically connected to provide for a multi-

channel listening experience. Please

refer to the amplifier's owner manual for

particular connection instructions and

see chapter "Multichannel loudspeaker

setup" on page 10 for further help.

Connecting

P17