Dynaudio Sub 6 Manuale d'uso - Pagina 11
Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Dynaudio Sub 6. Dynaudio Sub 6 20.
Stampa la pagina
Positioning Possibilities
Moving the subwoofer closer to walls
Next to wall, away from corner
and corners in particular will generally
This position still provides considerable
increase the amount of bass. Although
boost but less than the corner placement
the extra amount of bass can be
as above. Room-modes can also still be
compensated for by reducing the volume
considerable but less so than with corner
level of the subwoofer relative to the
placement.
rest of the system, this can result in
From the listening position, check
•
uneven bass response at the listening
if the bass is even across the entire
position. You can try starting with
bass spectrum. If not, move the
placement in a corner and experiment
subwoofer away or towards your
by gradually moving it out of the corner
listening position until the most even
or further away from the wall. Try to
response has been obtained.
locate the position which yields the best
Avoid placing the subwoofer exactly
•
compromise between position, volume
half-way or at a quarter of the wall's
and even bass response. Note that every
length.
time that you reposition the subwoofer
(even if it's over a short distance) you
Free standing, away from wall and
may need to adjust its settings.
corner
This position will give least boost
Corner placement
compared to wall or corner placement,
This placement yields maximum boost
but in general offers the best flexibility at
of bass level but potentially uneven
achieving most even bass distribution at
distribution of bass in the room (room-
the listening position.
modes), particularly if the room is square
•
Avoid placing the subwoofer exactly
or shoe-box shaped.
half-way or at a quarter's length of
From the listening position, check
either sidewall.
•
if the bass is even across the entire
Particularly in smaller square or
•
bass spectrum. If not, move the
"shoe-box" shaped rooms the free
subwoofer out of the corner. Try
standing position is recommended.
moving it along either wall.
20
Sub 6 DSP Features
The Sub 6 incorporates signal
processing that can compensate for the
time delay and volume level differences
between the subwoofer and main
speakers resulting from their relative
positions with respect to the listening
position. Once you have positioned your
subwoofer, measure the distances as
illustrated in the diagram. The measured
distances should then be specified at the
appropriate locations in the subwoofer
configuration menu. The configuration
menu is described in the following of this
manual.
Note
The Sub 6 signal processing
is able to compensate for a
maximum of 5.35m difference
between subwoofer and main
speaker distances to the listening
position.
Left speaker
distance
Sub 6 Feet
The Sub 6 is supplied with rubber feet
hole leaving a length of spike extending
and option for spikes. Spike feet are
beyond the lock-nut so that when the
intended to be used on carpeted solid
subwoofer is upright the lock-nuts will
floors. The spikes pierce the carpet to
"float" just above the carpet.
support the subwoofer on the floor below
Tighten three of the lock-nuts with the
protecting the carpet from damage and
included spanner leaving one locknut
providing a stable foundation.
finger-tight to aid adjustment once the
subwoofer is placed in its final position.
If floor spikes are to be used, screw a
Once the final position has been
spike and lock-nut into each tapped
established adjust the length of the loose
Subwoofer
distance
Right speaker
distance
Listening area
spike so that the subwoofer is level and
does not rock. Finally, tighten all loose
lock-nuts.
Take care when installing floor spikes.
They are sharp and can cause injury.
Installation
21