Dynaudio Sub 6 Manuale d'uso - Pagina 14
Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Dynaudio Sub 6. Dynaudio Sub 6 20.
Stampa la pagina
Subwoofer Control
Configuration and Use
With the Sub 6 subwoofer positioned
Note down settings
in the listening room and connected to
When looking for the best subwoofer
signal cables and mains power it can be
position in the room, note down the
switched on via the mains switch above
ideal setting you found for a position.
the mains input socket on the rear panel.
When moving the subwoofer between
two positions you will be able to set the
The Sub 6 must be configured
subwoofer to the same configuration as
appropriately for the audio system and
found before.
main speakers with which it is to be
used. This is achieved via the rotary
Vary the listening music
controller, display and menu based
When experimenting to find the
interface on the rear panel. Turn the
optimal settings, use a couple of music
rotary controller to select configuration
tracks with repetitive bass across a
parameters and press the control to
large spectrum. The tracks should be
select options and save any changes.
sufficiently different from each other and
each should cover a wide bass-range.
General Tips
Musical instruments, such as a double-
Check it out
bass, bass guitar, church organ, etc.
Try different subwoofer positions and
covering a wide spectrum in the bass
settings, before you finally choose a
region and above, are very suitable as
setup.
these depend on accurately balanced
subwoofers and main speakers.
26
Rotary controller:
Rotate to select.
Press to confirm.
Verify changes
Although in general it is best to make
adjustments in the sequence outlined
below, note that changing one setting
may influence another. For example,
finding the right setting for phase may
result in having to decrease gain, even if
this was set correctly before.
It is recommended that you double-
check the previous settings before
moving on to the next one. Obtaining
the best integration of the subwoofers
generally involves a considerable amount
of repeated fine-tuning.
Note
If multiple subwoofers are
employed they should be
configured identically.
Sub 6 Configuration Menus 1
The Sub 6 configuration menu
Setting Input Sensitivity
parameters and their options are
The wide variety of possible source equipment types that can be connected to an
described in the following paragraphs:
active subwoofer means that it is important to set the input sensitivity appropriately.
Doing so will help ensure that the subwoofer's volume adjustment range is adequate
•
Input sensitivity: Adjusts the input
and that its input and DSP electronics are driven properly.
sensitivity to match the output level
of your pre-amplifier or audio-visual
If the source equipment has a published specification for output level, begin by
processor.
setting the Sub 6 input sensitivity to match the specification as shown in this table:
Source Output Level
•
Volume: Set to match the volume of
<1.0V
your main speakers so that bass at
<2.0V
your main listening position is neither
<4.0V
too prominent or too quiet. Setting
<10V
the subwoofer volume is important in
terms of both overall system balance
The -14dB sensitivity setting should generally be used when the Sub 6 is used for
and the demands of different types
the LFE channel in a home theatre system.
of programme material.
If the source equipment has no published output level specification, begin by setting
the Input Sensitivity to -6dB. If then when in use the Sub 6 volume setting is required
to be towards either its maximum or minimum values, adjust the Input Sensitivity
appropriately such that the volume setting is towards the middle of its range.
Configuration and Use
Sub 6 Setting
+6dB
0dB
-6dB
-14dB
27