Gallien-Krueger MB Fusion 800 Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Gallien-Krueger MB Fusion 800. Gallien-Krueger MB Fusion 800 12.
Stampa la pagina
F U L L P O W E R
5 8 0 W
A C I N P U T
12 0 V / 6 0 H z
1
Rear Panel Features
AC Receptacle: The detachable power cord
1
plugs in here.
Ground Lift: This switch disconnects the
2
ground of the balanced, XLR output to eliminate
hum and buzz when connecting to equipment
that is running on a different ground system.
Balanced Direct Out: This electronically
3
balanced output allows a direct connection to a
P.A. system.
Pre/Post EQ Button: This button switches the
4
direct out signal to be before or after the EQ.
Foot switch Input: A foot switch is provided to
5
engage Boost and Master B modes.
Tuner Output: This output comes directly off of
6
the input stage and can be patched to a tuner
using a shielded patch cord. This output is
unaffected by the Tuning Mute Feature.
Return: This input allows the signal from
7
outboard effects devices to be inserted before the
boost section.
Send: This output allows signal from the preamp
8
to be fed to outboard effects devices from a point
after the EQ section.
Headphone/Line
out/Chain
9
switched, this output allows the user to send a
direct (unbalanced) line out to devices with
unbalanced inputs such as personal multitrack
recorders. This connection requires a shielded
patch cord. The Chain out allows the user to
connect directly to a GK MBP powered
extension cabinet. This connection is made with
a balanced, tip, ring, sleeve to male XLR cable.
tip ring sleeve
Unswitched, this headphone jack can be used to
MB 500
D I R E C T O U T
G N D
E Q
F T . S W I T C H
GND
PRE
LIFT
POST
2
3
4
5
out:
When
male XLR
P A T C H B A Y
H E A D P H O N E S ( 1 )
L IN E OU T/CHA IN O U T (2 )
T U N E R
R E T U R N
F X
S E N D
6
7
8
9
monitor your playing with headphones.
Headphone/Line out/Chain Out switch: This
10
switch toggles the output from headphone to line
out.
Speaker: Power amp output to speaker cabinet.
11
Delivers 500w into 4 Ohm loads. Lower
impedances such as 8 Ohms or 16 Ohms and no
load are acceptable. One 4 Ohm speaker and one
8 Ohm speaker is not recommended. Use a two
conductor or the GK 4 conductor Speakon cable
only.
7
1
2
500 WATTS @ 4 OHMS
S P E A K E R
CLA SS 2 WI R IN G
10
11