Gallo Tech GTStarter-2 GTS-2 Manuale di funzionamento e installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di funzionamento e installazione per Avviamento a distanza Gallo Tech GTStarter-2 GTS-2. Gallo Tech GTStarter-2 GTS-2 15. Keyless rfid push button start & security system

Stampa la pagina

1. Key Fob & Programming Function Set up

Figure 1

Option 1 – The user has the option of keeping the original ignition switch or completely removing it. If the ignition is kept

operational, the vehicle can then be started with either the "Push Start/Stop" button or the ignition key. If eliminating the Ignition

Switch, cut all wires as shown. If the Ignition switch is not being eliminated do not cut the wires, the engine can then be started

with either the ignition key switch OR the "Push Start Stop" button.

Option 2 - Use this wiring to energize (Max 150 MA) an optional relay when your vehicle uses both an IGN 1 & IGN 2 circuits

during Starting & Run. The relay AMP rating will need to be high enough to carry the load for your vehicle's IGN 2 circuit..

Option 3 – For Automatic transmission connect "Start Enable Input" (yellow) wire to chassis ground "-". Engine will only start

when brake peddle is pressed. For Manual Transmission connect "Start Enable Input" (yellow) wire to the clutch peddle switch

that grounds "-" when the peddle is depressed. Reset Function Option #2 to Manual Transmission. Engine will only start when

the clutch peddle is pressed.

- 10 -

Rev. V8.2- 20212