Highway Equipment Company NEW LEADER G4 Come controllare - Pagina 3

Sfoglia online o scarica il pdf Come controllare per Spreader Highway Equipment Company NEW LEADER G4. Highway Equipment Company NEW LEADER G4 13. Spread pattern

Stampa la pagina

WARNING

Use the following instructions when installing a G4 Spinner Assembly on a New Leader L5034 G4

spreader:

*9 7/8 = 25.08cm

Figure A – Spinner Assembly Installation

Figure B – Shield Installation

3. See Figure B. Install the right-hand (Item 5) and left-hand (Item 6) spinner shields on the spinner

assembly and attach the shield brackets (Item 3) and stiffener bars (Item 4) to the shields using

hardware provided. Attach the spinner guard (Item 7) both spinner shields with hardware provided.

Tighten all shield hardware securely, including the front bolts of the spinner assembly.

4. Install the pressure, return and case drain hoses. Crank the spinner assembly all the way forward

and back to make sure the hoses and fittings do not interfere with the spinner assembly as it moves.

Tie all loose areas of hose together with wire ties to prevent contact with moving parts during

operation.

SPINNER ASSEMBLY INSTALLATION

Keep spinner assembly supported until mounting is complete. Never

exceed workload limits or use slings to lift items over people.

HIGHWAY EQUIPMENT COMPANY

1. Use a suitable lifting device to hoist the

spinner assembly (Item 1 - Figure A) onto

the rear of the sills.

assembly weighs approximately 500 lbs.

(154 kg) Align the spinner assembly holes

with the sill holes. Insert four carriage bolts

(Item 2) through holes, place shield brackets

(Item 3), then stiffener bars (Item 4) on front

bolts and attach with washers, lock washers

and nuts. Hand-tighten only. Remove the

two wooden 2 x 4's (5.08cm x 10.16cm) and

hardware used during shipping.

2. Make sure the spinner assembly is square.

Measure from the spinner mounting bracket

that sits on the sill to the end of the sill on

both sides.

The distance should be

approximately 9-7/8" (25.08cm) on each

side as shown in Figure A.

spinner assembly from side-to-side by

measuring from the spinner hub to the sill

on each side—these two measurements

should be equal.

securely.

Note: The spinner

Center the

Tighten the rear bolts

305438-SP-A

Page Rev. A