CORA CS1000 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Accessories CORA CS1000. CORA CS1000 17.

CS1000 Long Range Door Sensor – User Guide

Attaching to the Network

The device is shipped in a factory hibernate state. Once the sensor is removed from the

packaging, it can be activated by pushing the SET button once.

The device will activate, blinking orange four times and begin issuing join requests. The LED

status indicators is shown in the figure below.

Figure 2 – CS1000 LED Status Indicators

Periodically, the device will blink red twice while attempting to join. Assuming the device is

properly registered on an available network and in range, it should connect. It will blink green

four times to indicate it has joined.

Once joined, the device can be tested by moving the magnet away and near the main unit

sensor. By default, the device will generate open and closed alarms to notify the application that

the events have occurred. If the magnet remains away too long from the main sensor unit, time

alarms may also be issued.

Note: If the device has not joined within a few minutes, the LED will stop blinking, though it will

continue try to join: ten times in the first hour, then longer intervals over the first week until finally

attempting once every 12 hours. This is done to conserve battery power when the network is not

available for long periods of time. You may reset the join schedule by performing a Network

Reset on the device, see User Interface.

To learn more about the capabilities of the CS1000, see Configuration and Integration.

Page 4