Galvin Engineering Ezy-Drink Lead Safe 170.81.13.01 Istruzioni per l'installazione - Pagina 4
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Prodotto idraulico Galvin Engineering Ezy-Drink Lead Safe 170.81.13.01. Galvin Engineering Ezy-Drink Lead Safe 170.81.13.01 4. Remote push button drinking tap
v
TROUBLESHOOTING
PROBLEM
Inconsistent flow
Water is not flowing from
tap
Continuous flow
Rate of flow inadequate
Button hard to press
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including
but not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy
for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
CAUSE
Blocked top assembly
Water is turned off
Blocked flow regulating screw
Top assembly loose or
internally obstructed or
damaged
The flow regulating screw may
not be adjusted correctly
The mains pressure may be
too great
th
Version 1, 12
March 2020 Page 4 of 4
RECTIFICATION
Remove top assembly and clean
Turn on water
Remove flow regulating screw and
clean
Remove top assembly, clean with water
and re-grease spindle if required
Remove blanking screw and adjust flow
regulating screw as described above
Reduce to below 500kPa (70PSI). Re-
grease spindle if required