AGS Merlin 1000Si Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Controllore AGS Merlin 1000Si. AGS Merlin 1000Si 12. Gas safety products, gas utility controller
Anche per AGS Merlin 1000Si: Manuale d'uso e installazione (7 pagine), Manuale d'uso e installazione (9 pagine), Manuale di installazione e funzionamento (16 pagine)

Merlin 1000Si

3.3

BMS Integration

The Merlin 1000Si can be integrated with a BMS to make or break a circuit on

gas on/gas off, (valve open or valve closed).

This will tell the BMS whether or not power is being sent to the solenoid.

There is a dip-switch located on the inside facia of the panel labelled [BMS

SEL]. This is factory set to 'OFF' which signals the BMS on gas on/gas off.

When switched to 'ON', the 1000Si will only signal the BMS on a fault, i.e. high

CO2 level detected, gas detected, emergency stop pressed, etc.

3.4

The Merlin 1000Si has an auto-shut down feature after a selected time.

There are two dip-switches located on the inside facia of the panel labelled

[TIME1] & [TIME2].

Upon installation, these can be configured to select the required timeout/

shut-down period.

TIME 1

TIME 2

OFF

They are factory set to 'OFF' for a 2 hour timeout.

NOTE: Upon timeout/auto-shut down the gas supply will be turned off.

3.5

The Merlin 1000Si can be integrated with a fire alarm to close the gas supply automatically in

the event of a fire.

The volt free fire alarm signal can be wired in series with any remote emergency shut off

buttons. If there are no remote emergency stop buttons being installed, wire this directly to the

1000Si terminal marked [EM REMOTE].

Rev: 05

05-19

Timeout Period (Hours)

Disabled

User Guide