AGS MERLIN CO2-TFT Manuale di installazione, funzionamento e manutenzione - Pagina 11
Sfoglia online o scarica il pdf Manuale di installazione, funzionamento e manutenzione per Strumenti di misura AGS MERLIN CO2-TFT. AGS MERLIN CO2-TFT 16. Carbon dioxide & temperature monitor
Stampa la pagina
Installation, Operation & Maintenance Manual
OPERATION
First Power Up
On connecting power, the CO2-TFT monitor enters a stabilisation phase for approximately 60 seconds –
during this period, your device not yet ready for operation.
a. CARBON DIOXIDE READING. Current CO
b. 0-10V ANALOGUE OUTPUT PROGRESS BARS. 0-10V analogue outputs 1 and 2.
c. FLAME ICON appears only when the CO2-TFT receives a signal from a gas valve and gas supply is
open/on and set to Natural or Mechanical Ventilation Type mode.
d. BOOST ON message appears when BOOST is activated - press and hold the touch button (f) for
three (3) seconds. The analogue outputs will run at optimum voltage (10V) for a pre-set number of
minutes. Boost can only be activated if either analogue outputs is set to CO2 or DUAL mode only.
e. MUTE message appears when the touch button (f) is pressed. The audible alarm buzzer must be set
to on or every 10 minutes and can only occur when gas is in use or KITCH. Ventilation mode is
selected and when CO
f.
TOUCH BUTTON used to activate 'Boost' or 'Mute' dependant on the status and also to view the
screen for 10 seconds during screen saver mode.
g. TEMPERATURE READING. Current temperature in degrees Celsius or Fahrenheit. The temperature
will increase its accuracy over a 30 minute period upon power up.
h. GAS IN USE MESSAGE appears only when the CO2-TFT receives a signal from a gas valve and gas
supply is open/on. When the gas valve is closed, this message will not be displayed. Appears with
Flame icon.
i.
BLANK (Natural or Mechanical mode), this is left blank when the current CO
550ppm. In Kitchen ventilation mode – this is constantly left blank.
j.
AVERAGE CO
CALCULATION. The monitor will display the average CO
2
hours and appear only when current CO
ventilation type modes only.
Rev 3 11-20
gas level in parts per million (ppm).
2
levels rise above 2800ppm.
2
levels reach or exceed 600ppm in Natural or Mechanical
2
CO2-TFT
reading is below
2
reading over periods of 8
2
11