Dynojet Power Commander III USB 109-411 Istruzioni per l'installazione - Pagina 5
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Accessori per moto Dynojet Power Commander III USB 109-411. Dynojet Power Commander III USB 109-411 5. 2002-2004 honda vtx 1800c, 2002-2003 honda vtx 1800r
Stampa la pagina
Supplied power lead
Location: T op
of ECU, 2nd
pin from left
Power lead
i109-411
www.powercommander.com
Red wire from PCIII
Black wire with white tracer
Follow these additional instruc-
tions for European models only.
1
Plug the supplied power lead
to the red wire of the PCIII
(Fig. J).
2
Locate the black wire with a
white tracer on the grey connec-
tor side of the ECU (Fig. K).
3
Connect the supplied wire tap to
this wire.
Make sure the tap is
completely closed (Fig. K). It is
recommended to use dielectric
grease inside this connector.
4
Connect the other end of the
power lead to the wire tap
(Fig. K).
Note: It is recommended to use dialec-
tric grease on this connection.
Power for the Power
Commander is supplied from the
tail light circuit.
specification bikes it is possible
to switch the light circuit off (via
the handlebar switch).
shut off the power to the Power
Commander causing the bike to
stall.
It is necessary to use the power
lead adapter and wire tap on
European bikes to maintain con-
stant power to the Power
Commander.
to use these parts on a U.S spec-
ification bike as there is no per-
formance advantage.
On European
This will
It is not necessary
VTX 1800 - PCIII USB - 5