GAM TwinSpin Manuale di istruzioni per l'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Apparecchiature di illuminazione GAM TwinSpin. GAM TwinSpin 6. 1 motor
Stampa la paginaMODE 1 OPERATION -- MODE SWITCH = 1 -- 1 CHANNEL OPERATION
•
Speed and position control on a single fader
•
Set DMX address - This number will correspond to channel control for the rotator
•
The indexing gobo is controllable according to the following table:
FADER %
100%
76 to 99%
75%
51 to 74%
50%
0 to 49%
All indexing takes place at 5 Rpm.
MODE 2 OPERATION -- MODE SWITCH = 2 -- 2 CHANNEL OPERATION
•
Separate speed and position control
•
Set DMX address
•
The indexing gobo is controllable according to the following table:
FADER %
Speed - channel 1
100%
50 to 99%
50%
1 to 49%
0%
FADER %
Speed - channel 2
1 to 100%
0%
•
If the indexing channel is set to zero, then the gobo will continuously rotate according to the setting of the speed channel.
•
In Index Mode (channel 2 is set above 1%), the gobo will take the shortest route to its position.
•
The speed of indexing is set by channel 2 and for index mode, the speed-control-channel stop positions are not used.
0% is full speed indexing
•
50
% is 0.1 rpm indexing
.
•
100% (full) is full indexing
•
HEXADECIMAL
FUNCTION
255 = FF
STOP
193 to 254
0.1 to 25 Rpm counterclockwise
191 to 192
STOP
129 to 190
25 to 0.1 Rpm clockwise spin
128
STOP
0 to127
Index 0 to 359 degree at 5 Rpm shortest route
HEXADECIMAL
255 = FF
129 to 254
128
0 to 127
0
HEXADECIMAL
0 to 255
0
FUNCTION
1. Speed and direction of continuous spin
STOP
25 to 0.1 Rpm counterclockwise spin
STOP
0.1 to 25 Rpm clockwise spin
STOP - at position set by indexing fader
FUNCTION
Index / Position of gobo
Index position (8 bit) 0 - 359 degrees
Continuous rotation as set by speed channel
Pag e 2 of 6
12/06