CORBERO CF2P2600W Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero CORBERO CF2P2600W. CORBERO CF2P2600W 14.

24 hours before adding food. The thermostat knob controls the temperature. When the

thermostat control knob is set to OFF, the refrigerator will not be running.

4.2 Noise Inside the Unit!

You may notice that your unit makes some unusual noises. Most of these are perfectly normal,

but you should be aware of them!

These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has

become more pronounced since the introduction of CFC free gases. This is not a fault and will not

affect the performance of your unit. This is the compressor motor working, as it pumps the

refrigerant around the system.

Cooked meats/fishes should always be stored on a shelf above raw meats/fishes to avoid

bacterial transfer. Keep raw meats/fishes in a container which is large enough to collect juices

and cover it properly. Place the container on the lowest shelf.

Leave space around your food, to allow air to circulate inside the unit. Ensure all parts of the

unit are kept cool.

To prevent transfer of favours and drying out, pack or cover the food separately. Fruit and

vegetables do not need to be wrapped.

Always let pre-cooked food cool down before you put in the unit. This will help to maintain

the internal temperature of the unit.

To prevent cold air escaping from the unit, try to limit the number of times you open the

door. We recommend that you only open the door when you need to put food in or take food

out.

Lamp replacement by professionals

Remove all the shelves and the salad bin. To remove the salad bin first remove the lower

door shelf.

Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with

warm water using a wrung-out

shelves and salad bin.

Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish. Make

sure that the door is closed to avoid the polish getting on the magnetic door seal or inside

the unit.

The grille of the condenser at the back of the unit and the adjacent components can be

vacuumed using a soft brush attachment.

Condensation may appear on the outside of the unit. This may be due to a change in room

temperature. Wipe of any moisture residue. If the problem continues, please contact a qualified

technician for assistance.

sponge or cloth. Wipe completely dry before replacing the