CORBERO FC 1801 I Libretto di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Libretto di istruzioni per Frigorifero CORBERO FC 1801 I. CORBERO FC 1801 I 10.

Open both the appliance door and that of the

kitchen unit to approx. 90°. Place the little plates

over the runners. Hold the doors of the appli-

ance and the unit together and mark the holes.

Remove the little plates and make the holes

with a diam. of 2 mm. Replace the little platee

over the runners and screw in the screws

provided (3.5x16 mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that

the doors of the appliance and the kitchen unit

open properly.

If the appliance is fixed to the side of the kitchen

unit, simply slacken the screws in the fixing

brackets (G), move the brackets as shown in

the figure and re-tighten the screws.

The doors can be opened using the sliding

system previously illustrated, or one of the two

doors can be opened by fitting the small handle

supplied as an accessory (see figure).

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate

correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For

operation with different voltages, a suitably sized auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

TECHNICAL SPECIFICATIONS

8mm

PR34

PR35

D735

D029

Fig. 9

Fig. 10

Fig. 11

Fig. 12