CORBERO FM850S/6 Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero CORBERO FM850S/6. CORBERO FM850S/6 12.
Stampa la paginaWarning! Never use sharp metal tools to scrape
off frost from the evaporator as you could damage
it. Do not use a mechanical device or any artificial
means to speed up the thawing process other than
those recommended by the manufacturer.
Periods of non-operation
When the appliance is not in use for long periods, take
the following precautions:
What to do if...
Warning! Before troubleshooting, disconnect
the mains plug from the mains socket.
Only a qualified electrician or competent person must
do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Problem
The appliance is noisy
The appliance does not oper-
ate. The lamp does not oper-
ate.
The lamp does not work.
The compressor operates
continually.
Water flows on the rear plate
of the refrigerator.
Possible cause
The appliance is not supported prop-
erly
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correctly. Set a higher temperature.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high. Let the product temperature decrease
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
1. disconnect the appliance from electricity supply
2. remove all food
3. defrost and clean the appliance and all accessories
4. leave the door/doors open to prevent unpleasant
smells.
Important! If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Important! The appliance operates discontinuously,
so the stopping of compressor does not mean being no
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
Check if the appliance stands stable
(all the four feet should be on the floor)
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
to room temperature before storage.
Decrease the room temperature.
This is correct.
Solution
7