AFL ASCEND Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Hardware di rete AFL ASCEND. AFL ASCEND 4. Splice cassette
Anche per AFL ASCEND: Istruzioni per l'installazione (4 pagine)

Stampa la pagina
CASSETTE INSTALLATION
This installation guide is applicable for any ASCEND cassette. Cassettes can be inserted from the front or rear of the housing. It is recommended to begin cassette
installation from the bottom and fully populate each tray before moving upward.
FRONT INSTALLATION INSTRUCTIONS
1.
Pull out the desired installation tray. A hard stop will be felt when the tray reaches the correct installation position (Figure 2).
2.
Relative to the front of the cassette, push in on the cassette's release lever to ensure it is engaged (Figure 3).
3.
Align the cassette within the guides inside of the tray and push the cassette into the tray (Figure 4).
4.
To release the cassette from the front of the tray, pull out on the release lever and slide the cassette out of the tray guides (Figure 5).
Note: If desired, a hook tool can be placed in the hole on the release lever to assist in removing the cassette from the tray. Use
extreme caution and care if using this method.
5.
Re-engage the release lever to insert the cassette back into the tray. A click should be heard when the lever is re-engaged.
Figure 2
REAR INSTALLATION INSTRUCTIONS
1.
Ensure that the front door of the housing is closed.
2.
Open the rear door of the housing.
3.
For easier access to trays, remove the rear housing cover by unscrewing the two thumbscrews (Figure 6).
4.
Relative to the front of the cassette, push in on the cassette's release lever to ensure it is engaged (Figure 7).
5.
Align the cassette with the guides inside of the tray and push the cassette into the tray (Figure 8).
6.
To release the cassette from the rear of the tray, push forward on the release lever and slide the cassette back toward you (Figure 9).
7.
Re-engage the release lever to insert the cassette back into the tray. A click should be heard when the lever is re-engaged.
Figure 6
PATCH CORD INSTALLATION
1.
Pull out the desired installation tray. A hard stop will be felt when the tray reaches the correct installation position.
2.
While holding the extension tab on the latch mechanism, plug the connector in to the desired port by pushing on the latch mechanism (Figure 10).
3.
Route the cable one at a time through the organizing rings (Figure 11).
Note: Each ring is designated to a cassette. Patch cords, plugged in to the cassette nearest the exit to the vertical cable management,
are routed through the ring closest to the cassette. Patch cords plugged in to the second cassette are routed through the ring
second closest to the cassette, and so forth.
Note: The cables can all be routed to one side of the housing, or can be split by routing half to the left and half to the right of the housing.
4.
To remove the connector, pull on the latch mechanism (Figure 12).
Figure 10
2
Figure 3
Figure 7
Figure 11
(800) 235-3423 • (864) 433-0333 • AFLglobal.com
Figure 4
Figure 8
Figure 12
Figure 5
Figure 9
INS-01005