GAMA Electronics RF340-100APR Manuale di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per Ricevitore GAMA Electronics RF340-100APR. GAMA Electronics RF340-100APR 4.

WWW.GAMAINC.COM

Each transmitter has its own unique internal address along with the data as to which button is pressed and transmitted.

The receiver needs to be programmed to respond only to the specific transmitter it is intended to operate with. The

following steps configure the receiver to operate with a particular transmitter. Up to 30 transmitters can be programmed

to one receiver. Please read the entire programming procedure before starting. When the receiver enters program

mode, all previous transmitter addresses that were programmed will be erased from the receiver's memory.

1. Locate the pushbutton switch labeled "PROGRAM" on the receiver. Press and hold this switch until the red LED next

to the program switch illuminates (approximately 3 seconds). The receiver is now in transmitter program mode, release

the switch. At this point all previously programmed transmitter addresses are erased from the receiver's memory.

2. For momentary operation, press and release a switch on the transmitter. The red program LED on the receiver will

blink once. For latching operation, press and release the same switch a second time, the program LED will flash on and

off.

3. Repeat the previous step for additional transmitters that you desire the receiver to respond to.

4. The receiver will return to normal mode if no transmitter switches are pressed for 5 seconds. The red LED on the

receiver will flash and then turn off. The receiver is now in the normal mode of operation. This completes the

programming instructions. The receiver will retain all of its programming even when power is removed.

Long Range

Bypass Wire

(Cut if using long

range antenna)

Connector

Toggle Switch

Programming Instructions

RF340-100APR

Instruction Manual

Long Range

Antenna Jack

Programming

Switch

Page 2 REV A 07/10/20

LED