Gama Garden GCS-2200E Manuale di istruzioni - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per Motosega Gama Garden GCS-2200E. Gama Garden GCS-2200E 18. Electric chain saw
Stampa la pagina•
Do not use the chainsaw to remove or similar
objects.
When lopping off branches, the chain saw
•
should be supported wherever possible against
the trunk, Do not cut with the tip of the guide
bar (risk of kick-back! see Fig. 7).
•
Leave branch lopping work should be carried
out by trained personnel! Risk of injury!
Pay special attention to branches under
•
tension. Do not cut through freely suspended
branches from underneath.
•
Never stand on the trunk when loping off
branches.
•
The chainsaw should not be used for forest
work, i.e. for felling and lopping off branches in
the forest. Because of the cable connection
the saw operator does not have the necessary
mobility and his safety is not guaranteed!
•
Always stand to the side of the tree being
felled.
When the tree is being felled, watch out for
•
falling branches when stepping back.
•
On slopes the saw operator should stand to
the upper or left or right side the trunk or lying
tree, never to the bottom side.
Watch out for trunks rolling towards you.
•
Kick-back!
•
The power saw is likely to recoil if the tip of the
guide bar (especially the top quarter)
accidentally touches wood or any other solid
objects. In this case the saw will move
uncontrolled and will be hurled towards the
operator at full power (risk of injury!).
In order to prevent kick-back, please follow
these safety instructions:
•
Never start cutting with the tip of the guide
bar!
Never cut with the tip of the guide bar! Be
•
careful, when continuing cuts you are already
working on!
Always start cuts with the chainsaw already
•
running!
•
Make sure that the saw chain is always
properly sharpened.
•
Never cut through more than one branch at a
time! When lopping off branches, be careful
not to touch any other branches.
When cross-cutting, pay attention to trunks
•
standing very close to each other. If possible
use a saw-horse.
Transporting the chainsaw
Before transporting the chainsaw, always remove
the plug from the power socket and slide the
chain guard over the rail and chain. If several
cuts are to be performed with the chain saw, the
saw must be switched off between cuts.
Before starting up
The voltage and current supply must comply with
the ratings on the type plate. Before commencing
work, always check that the chainsaw works
properly and is safe to operate.
Check also that the chain lubrication and the oil
gauge are in good working order (see Fig.2).
When the oil lever is approx. 5 mm from the
bottom mark, you must top up with oil. When the
oil level is above this mark you can work without
worry.
Switch on the chain saw and hold it above the
ground. Be careful not allow the chainsaw to
touch the ground. For safety reasons it is best to
keep a clearance of at least 20 cm. If you now
see growing traces of oil, the chain lubrication
system is working correctly. If there are no traces
of oil at all, try cleaning the oil outlet (Fig. 2, A),
the upper chain tensioning borehole and the oil
duct, or contact your Customer Service. (Be sure
to read the section "Filling in chain oil and chain
lubrication" on this point).
Check the chain tension and retention if necessary
(see the section "Tensioning the saw chain" on
this point). Make sure the chain brake is working
properly (see also the section "Releasing the chain
brake").
Filling in chain oil
To prevent dirt getting inside the tank, clean the
oil tank cap (B) before opening. Check the
9
(Fig 2)