Airelec Agate Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Riscaldatore Airelec Agate. Airelec Agate 2. Bathroom heater

Agate Bathroom Heater

The Airelec Agate Heater is practical and discreet and is recommended for

bathrooms, kitchens etc

Specifications

Resistance with low thermal inertia • Control knob • Automatic thermal safety •

Steel casing • Polymerised polyester epoxy paint • Air outlet louvre in the unit •

Colour: white satin • Class II / IP 21 - 230V, 50Hz • Weight 3 kgs • Dimensions

343mm (l) x 230mm (h) x 114mm (d)

Installation

• The Airelec Agate heater must be installed by a registered electrician.

• All fixed wiring must be protected.

• This Class II appliance does not require an earth connection. It must be positioned with the grid (or the

horizontal air outlet) directed downwards.

• All pole disconnection must be provided in the fixed wiring for this appliance in accordance with AS/NZS

3000:2007.

• The appliance should be mounted at a minimum height of 1.8m from the floor and 30cm from the ceiling. It

must also not be less than 250mm from any adjacent projecting surface.

• When installing in a bathroom, the appliance must be installed so that switches and other controls cannot be

touched by a person in the bath or shower.

• Avoid positioning the appliance behind curtains, doors to ensure that the airstream is not obstructed when in

use.

• The appliance must not be located immediately below a socket outlet.

• Caution : DO NOT COVER THE HEATER (To prevent overheating, do not cover the heater).

Mounting Procedure

• Unhook and remove the backrest (Fig 2): unclip and unhook the legs

• The backrest must be fixed to the wall using 3 screws (max diameter 5.5mm); ensure that the clips are at the

bottom). Note the safety distances shown in figures 3 and 4.

Connection

• The appliance is double insulated and does not require an earth connection.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified

persons in order to avoid a hazard.

Before attaching the heater on the backrest,

select the wattage required (1000W or 2000W)

by turning the power switch on the back of the

heater. It is possible to change the power from

1000W to 2000W at any time by turning this

switch.

186 cms

from the

floor

Dimensions in cm

(ceiling)

Dimensions in cm