Hikobike ENDURO 2022 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Bicicletta Hikobike ENDURO 2022. Hikobike ENDURO 2022 17.

BATTERY STORAGE

Your battery likes the same temperatures you do. Store your battery somewhere dry with

a temperature between 15-25 °C. Do not leave it on the bike somewhere that it is likely to

freeze.

When storing the battery for periods longer than 2 months, fully charge the battery and remove the

charger from the wall socket. The battery has a 4-bar charge indicator on the battery pack. Push the

button to see how many bars light up, or the colour of the charge light. Try to keep the battery with

at least 2 bars showing on the controller, or several lights on the battery itself.

The Li-Ion battery will slowly lose its charge over long storage intervals. It is important to check and

charge the battery at least every 3 months and keep the battery charged between 25% and 100%.

Never leave your battery fully discharged as it may cause permanent damage to the battery.

Allowing the battery to fully discharge during long storage can destroy your battery.

SUSPENSION ADJUSTMENT

Your Hikobike has been set up for an average rider and so for most people will not need altering.

However, you can adjust both the seat suspension and the front fork suspension for either a harder

or softer ride or for heavier or lighter riders.

To adjust the seat suspension: Undo the seat post lever clamp and pull the saddle and post

completely out. At the bottom of the seat post there are slots. Use a coin or a large flat screwdriver

in these slots to either tighten to increase the tension or loosen to reduce it. Reinsert the seat post

and set at your preferred height and do up the lever clamp.

To adjust the fork coil spring preload: The fork can be adjusted to the rider's weight and preferred

riding style via the spring preload. It is not the coil spring hardness that is set, but the spring preload.

This reduces the "SAG" of the fork when the rider sits down. A medium hardness spring is used as

standard setting. Turn the preload adjust knob clockwise to increase the spring preload and turn it

anticlockwise to reduce it. Other adjustments are best done with your dealer.