Gama Sonic 214001 Manuale - Pagina 3
Sfoglia online o scarica il pdf Manuale per Lanterna Gama Sonic 214001. Gama Sonic 214001 4. Stainless steel bollard solar lamp with ez anchor
Stampa la paginaC.
TOP
B.
RING
ASSEMBLY
A.
BOLLARD
POLE
WARNING: GAMA SONIC
in other electrical sockets. They are low-voltage light
bulbs that are built and designed for our products only!
page 3
Light bulbs are not to be used
®
Operation and assembly instructions.
1. Remove the Adaptor from the base by
unscrewing the two silver caps from the
bottom of the Bollard Pole (A).
2. Secure the Ring Assembly (B) to the Bollard
Pole (A) using the glass and twisting it
clockwise.
NOTE: If the two parts do not easily fit, try
inserting the glass into the Bollard Pole at an
angle until the glass starts to thread in.
3. Insert the GS Solar LED Bulb into the Top (A)
by screwing it in clockwise.
4. Set the operation switch to one of the
following settings:
High = Brighter light output
Low = Softer light, longer duration.
5. Connect the Top (A) to the Ring Assembly
(B) by twisting clockwise.
6. The Solar light will automatically operate
from dusk to dawn.
Flat surface installation Instruction
1. Using the Adaptor as a template, drill two
holes no larger than the anchors in the
desired mounting location.
2. Insert the anchors in the holes and secure
the Adaptor using the provided screws.
3. Attach the assembled lamp to the Adaptor
and secure using the silver caps.
EZ Anchor installation
1. Insert the Auger bit into the Adaptor and
secure it from the bottom using the four
supplied screws.
2. Place the Turning bar in the hole through
the Auger bit and begin turning the Auger
clockwise in the desired mounting location.
3. Apply downward pressure while turning
clockwise and occasionally check the level in
the Auger so it is vertical.
4. Stop turning once the Ground Stop Ring is
flush with the ground.
5. Remove the turning bar and place the
assembled lamp on the Adaptor.
6. Secure the lamp with the two silver caps.