MAINLINE ML135W Istruzioni per l'installazione Cura e manutenzione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione Cura e manutenzione per Servizi igienici MAINLINE ML135W. MAINLINE ML135W 11. Round front toilet

Stampa la pagina
Round Front Toilet
Devant de cuvette rond
Installation Instructions, Care and Maintenance
7
Install Tank
a. Check the rubber gasket,
Insert onto threaded end of
flush valve. (if not installed)
b. Tank bolts and plastic
locknuts are pre-install at
the factory. Remove the
plastic locknuts. (or the brass
hex nuts and washer)
c. Place tank back on bowl.
Make sure that the bolt
aligned to the bowl bolt
holes and rubber gasket fits
evenly.
Level tank and bowl.
d. Install plastic locknuts onto
bolt. Repeat for the other
side. Tighten plastic locknuts
evenly. "Hand-tighten only
DO NOT OVERTIGHTEN for
risk of breaking chinaware" .
Brass Hex Nuts - "Optional
Parts (to replace plastic
locknuts)
WARNING!
DO NOT OVERTIGHTEN"
VITREOUS CHINA
8
Install Toilet Seat
a. Install toilet seat in
accordance with
manufacturer's directions.
(NOTE: Toilet seat not included)
9
Connect Water Supply
a. Before continuing, determine the type of water supply connection
you have from the chart below and use the appropriate assembly
parts required to peroperly re-connect the water supply.
Do NOT use plumber's putty to seal these fittings.
Metal/Copper Flared Tubing
Tubing - These parts must be used as illustrated
to insure a water-tight connection. Use of existing
coupling nut may result in water leakage. Water
supply tube or pipe must extend at least 1/2"
inside threaded shank of valve (does not apply to
flanged tubing).
Metal Flanged Tubing
Use existing coupling nut and washer
Metal Spiral Tubing
Use existing spiral cone washer.
R&T Plumbing cone washer may not seal
completely on spiral type supply line
Vinyl/Braided Connector
Captive cone washers already included.
No additional washers needed.
b. With correct washers in place
(See previous step), tighten
COUPLING NUT 1/4 turn
beyond hand tight.
DO NOT OVERTIGHTEN