aireRyder F0050 Manuale di avvio rapido - Pagina 5

Sfoglia online o scarica il pdf Manuale di avvio rapido per Ventilatore aireRyder F0050. aireRyder F0050 9. Original ceiling fan

Stampa la pagina

INSTALLATION INSTRUCTIONS

IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 18.7 lbs (8.5 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failing to do so can result in serious injury.

Installation Steps :

Fig.1
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
Fig.3
Lock Pin
Hanger Pin
Remove the Lock Pin and take off
the Hanger Pin.
Fig.6
Collar Screws
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it is locked into position.
Wood Member
(2" x 4" Approx.)
Ceiling
Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Fig.4
Motor Wires
Collar
Thread the motor wires through the
downrod stand cover, decorative
cap, canopy and downrod.
Fig.7
Lock Pin
PAGE: 5 / 9
Ceiling Joist
Junction Box
Hanger Bracket
Dry Wall Screw
Fig.5.
Fig.2.
Downrod
Canopy
Decorative Cap
Downrod Stand
Cover
Hang the fan on Hanger Bracket, and
Hanger Bracket
make sure the slot of hanger ball is
snapped into the chip of Hanger
Bracket exactly.
Slot
Note: For slope ceiling installation,
make sure the slot of hanger ball and
Chip
the chip of hanger bracket face down.
Wood Member
Ceiling Joist
(2" x 4" Approx.)
Ceiling
Washer
Hanger Bracket
Safety Cable Hook
Fig.5
Decorative Cap
Downrod Stand
Cover
Collar
Hanger Pin
Loosen the collar screws in part way.
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
F
A
Junction Box
Downrod
Canopy
N
C
O
171120