aireRyder FN44322 Manuale - Pagina 5
Sfoglia online o scarica il pdf Manuale per Ventilatore aireRyder FN44322. aireRyder FN44322 8.
Stampa la pagina
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.
SAVE ALL INSTRUCTIONS.
NOTE: The fan weight is 17.8 lb (8 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Installation Steps :
Fig.1
Turn OFF the electric power at the
main fuse or circuit breaker box.
Housing
Fig.3.
(For ceiling mount only):
Attach the canopy to the housing
with three ceiling mount screws.
Go to Fig.9 for the next step.
Fig.6
Motor Wires
Hanger Pin
(For downrod mount only):
Insert the Downrod into the Collar.
Slide Hanger Pin through holes of
Collar and Downrod.
Wood Member
Ceiling Joist
(2" x 4" Approx.)
Ceiling
Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Fig.4
Hanger Pin
(For downrod mount only):
Remove the Lock Pin and take off
the Hanger Pin.
Fig.7
Collar Screws
(For downrod mount only):
Insert and tighten the two Collar
Screws. Slide Lock Pin into Hanger
Pin until it locks into position.
PAGE: 1 / 4
Wood Member
(2" x 4" Approx.)
Ceiling
Washer
Junction Box
Hanger Bracket
Dry Wall Screw
Fig.2.
Fig.5.
Fig.5
Lock Pin
Motor Wires
Downrod
(For downrod mount only):
Slide canopy and downrod stand
cover onto downrod, as shown;
Then thread motor wires through
downrod.
Fig.8
Lock Pin
(For downrod mount only):
Hang fan on hanger bracket, and
rotate the downrod until the chip on
the hanger bracket snaps into the slot
on the hanger ball.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket are toward
the floor.
Ceiling Joist
Junction Box
Hanger Bracket
Safety Cable Hook
Canopy
Downrod Stand
Cover
Hanger Bracket
Slot
Chip
090218