Mainstays MS44-305-004-01 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Camino da esterno Mainstays MS44-305-004-01. Mainstays MS44-305-004-01 20. Lp gas outdoor fireplace

Stampa la pagina
Mainstays MS44-305-004-01 Manuale d'uso
Need help? 1.800.762.1142
Do not return to place of purchase.

Operating Instructions

Checking for Leaks

W WARNING: Before using this outdoor
fireplace, make sure you have read,
understand and are following all
information provided in the "Dangers
and Warnings" section on page 2.
Failure to follow those instructions
can cause death, serious injury or
property damage.
Burner Connections
1.
Make sure the regulator hose and valve
connections are securely fastened to the burner
and the tank.
2.
Visually check the connection between the
burner/venturi tube and orifice.
3.
Make sure the burner/venturi tube fits over the
orifice.
W WARNING: Failure to inspect
this connection or follow these
instructions could cause a fire or an
explosion which can cause death,
serious bodily injury or damage to
property.
4.
Please refer to diagrams for proper installation
(Figures 1 and 2).
5.
If the burner/venturi tube does not rest
flush to the orifice as shown, please contact
1.800.762.1142 for assistance.
Tank/Gas Line Connection
1.
Make 2-3 oz. of leak detection solution by
mixing one part liquid dishwashing soap with
three parts water.
2.
Make sure control knob is in the " OFF"
position (Figure 3).
3.
Connect LP gas tank per "Installing LP Gas
Tank" section.
4.
Turn LP gas tank valve to "OPEN."
5.
Spoon several drops of solution, or use a squirt
bottle, at all "X" locations (Figures 1 and 2).
a. If any bubbles appear, turn LP gas tank valve
to "CLOSED," reconnect and re-test.
b. If you continue to see bubbles after
several attempts, turn LP gas tank valve to
"CLOSED" and disconnect LP gas tank, per
"Disconnecting LP Gas Tank" section. Contact
1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, turn
LP gas tank valve to "CLOSED," wipe away
solution and proceed.

Lighting

W CAUTION: Keep outdoor gas
appliance area clear and free from
combustible materials, gasoline and
other flammable vapors and liquids.
W CAUTION: Do NOT obstruct the flow of
combustion and ventilation air.
W CAUTION: Check and clean burner/
venturi tubes for insects and insect
nests. A clogged tube can lead to a
fire.
W CAUTION: Attempting to light the burner with a cover on it may cause
an explosion.
1.
Make sure all labels, packaging and protective films have been removed from the outdoor
fireplace.
2.
Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the
burner/venturi tube. A clogged burner tube can lead to a fire.
3.
Control knob must be in the " OFF" position (Figure 3).
4.
Clear small area of lava rocks away from the pilot housing. (Figure 4)
5.
Connect LP gas tank per "Installing LP Gas Tank" section.
6.
Turn LP gas tank valve to "OPEN."
7.
Push and turn control knob to (HIGH). The burner should light. Repeat up to three times.
8.
Continue to hold the control knob in for 20 seconds to heat thermocouple.
9.
After 20 seconds, release and turn control knob counterclockwise to ignite burner and
adjust flame to desired height.
10. If ignition does not occur in 5 seconds, turn burner control knob to " OFF," wait 5 minutes,
fan with a newspaper or magazine, and repeat lighting procedure.
Figure 1
LP Gas Valve
Burner/Venturi
with Orifice
Tube
LP Gas
Burner Supply
Connection
Tube
Figure 2
X
X
X
X
X
Figure 3
OFF / APAGADO
Figure 4
Figure 5
15.75 in – 19.7 in
40-60 cm
Replacement Parts
parts.BlueRhino.com /
1.800.762.1142
11. If igniter does not light burner:
a.
Wearing heat-resistant gloves, position a long lit match or long lit butane lighter near
the pilot housing.
b.
Push and turn control knob to (LOW).
c.
Remove match/lighter once burner is lit.
W CAUTION: After lighting - using a fireplace tool and heat-resistant
gloves, carefully move the lava rocks back to their proper position,
being careful to avoid the flame.
12. After lighting, observe the burner flame. Make sure all burner ports are lit and flame height
matches illustration (Figure 5).
W CAUTION: If ignition does not occur in 5 seconds, turn burner control
knob to " OFF," wait 5 minutes, fan with a newspaper or magazine,
and repeat lighting procedure.

Turning Off

1.
Turn LP gas tank valve to "CLOSED."
2.
Turn control knob to the " OFF" position.
Note: A "poof" sound is normal as the last of the LP gas is burned.
3.
Disconnect LP gas tank per "Disconnecting LP Gas Tank" section.

Cleaning and Care

W CAUTION:
1. All cleaning and maintenance should be done when outdoor
fireplace is cool and with the fuel supply disconnected.
2. Do NOT clean any outdoor fireplace part in a self-cleaning oven.
The extreme heat will damage the finish.
3. Do NOT enlarge valve orifices or burner ports when cleaning the
valves or burners.
Notices
1.
This outdoor fireplace should be thoroughly cleaned and inspected on a regular
basis.
2.
Abrasive cleaners will damage this product.
3.
Never use oven cleaner to clean any part of this outdoor fireplace.
Before Each Use:
1.
Keep the outdoor fireplace area clear and free from any combustible materials, gasoline,
and other flammable vapors and liquids.
2.
Do NOT obstruct the flow of the combustion of LP gas and the ventilation of air.
3.
Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.
4.
Visually check the burner flames to make sure your outdoor fireplace is working properly
(Figure 5).
5.
See sections below for proper cleaning instructions.
6.
Check all gas connections for leaks.
7.
Check components for any signs of damage or rust.
8.
Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the
burner/venturi tube. A clogged burner/venturi tube can lead to a fire.
9.
If damage to any component is detected, do NOT operate until repairs are completed.
Cleaning Surfaces
1.
Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water.
2.
For stubborn stains, use a citrus-based cleaner and a nylon scrubbing brush.
3.
Rinse clean with water.
4.
Allow to air dry.
Before Storing
1.
Turn LP gas tank valve to "CLOSED."
2.
Turn control knob to the " OFF" position.
3.
Disconnect LP gas tank per "Disconnecting LP Gas Tank" section.
4.
Clean all surfaces.
5.
Lightly coat the burner with cooking oil to prevent excess rusting.
6.
Cover this outdoor fireplace with a durable vinyl cover.
7.
Store in a cool and dry location away from children and pets.
7