Agua CW501 Manuale di installazione e istruzioni per l'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Cappa di ventilazione Agua CW501. Agua CW501 15. High power range hood. cw500 series

Stampa la pagina

CANOPY RANGE HOOD INSTALLATION INSTRUCTIONS

WARNING

All electrical work must be done by a qualified electrician or person with technical background

and understanding.

Before beginning installation switch electric power off at central service panel

and lock service panel door so as to prevent power from being switched on accidentally. When

the power disconnecting means cannot be locked, securely fasten a prominent warning device to

the power service panel.

National electrical codes or prevailing local codes and ordinances.

INSTALLING A CANOPY RANGE HOOD

1. Determine the necessary height for the conduit and cut a 1-1/4" hole. Run wires through

the hole according to local codes and ordinances. Use caulking to seal all openings. Do

not turn the power on until completion of installation.

2. Find studs behind drywall with a stud finder. Make sure there is a stud or that the wall is

strong enough to support the weight of the range hood. If no stud can be found attach a

piece of wood or necessary supports to ensure the strength of the wall is enough to hold

the weight of the range hood. All fastener locations must span the studs, otherwise

proceed as follows:

a. Cut out drywall along marked lines;

b. Install support beams between studs and ensure that new supports are firmly flush

with existing stud front;

c. Make sure all the mounting screws will anchor to added studs;

d. Replace drywall and refinish.

3. Tighten the screws in three quarters of the way and hang the range hood. Hanging and

positioning the range hood will require at least two people and failure to do so may result

in injury.

4. Once the range hood is in place, tighten screws completely.

5. Level the machine using a carpenter's level across the bottom.

6. Attach shaft of the Canopy fan and adjust according to need. A small metal bracket can

be secured to the top of the shaft for better stability.

7. Connect ducting to transition and seal with duct tape.

Switch electric power off at central service panel and ensure power cannot be turned

back on accidentally prior to completion of installation.

electrical power source.

Do not use extension cord or adapter plug with this appliance. Follow National electrical

codes or prevailing local codes and ordinances

Do not use extension cord or adapter plug with this appliance. Follow

Connect range hood wires to