BriskHeat DHCSR Series Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Riscaldatore BriskHeat DHCSR Series. BriskHeat DHCSR Series 8. Drum / pail heaters

4. Replace the metal plate and secure with two screws.

CONNECTING HEATER TO AC POWER

1. The drum heater is designed to work at a specific voltage. Refer to

the lead wire label or stamp located on the heater for rated voltage and

wattage.

DHCH, DHCS, DPCH, DPCS, ECONO series

2. The power cable consists of three color-coded conductors, black,

white, and green. The black wire should be connected to Line 1. The

white wire should be connected to Line 2. The green wire should be

connected to earth ground. The power connections must be adequately

rated to electrically support the voltage and amperage of the heater.

The identification label located on the power cord displays voltage and

amperage requirements. Follow all local electrical codes for proper

electrical connections.

DHCX series

2. Connect the hazardous location approved plug to power source only

after all steps listed above are complete.

DHNH, DHNS, and DHNX series

2. Refer to external temperature controller instructions for power

installation instructions.

Do not adjust the low set-point higher than the high limit thermostat.

Do not adjust the low set-point higher than the high temperature set-

point connected to the indicator light.

Failure to operate the drum heater at its rated voltage could cause

damage to the heater, surface being heated, or contents of drum.

All electrical connections must be made by qualified personnel and in

accordance with all local codes and regulations.

Properly sized circuit breakers must be used.

The end-user is responsible for providing suitable electrical protection

device. It is highly recommended that a ground fault circuit breaker

be used.

BriskHeat

Silicone Rubber Band Drum / Pail Heaters