Bristan Blade Bath Shower Mixer BL BSM C Istruzioni per il montaggio ed elenco dei contenuti - Pagina 4

Sfoglia online o scarica il pdf Istruzioni per il montaggio ed elenco dei contenuti per Prodotto idraulico Bristan Blade Bath Shower Mixer BL BSM C. Bristan Blade Bath Shower Mixer BL BSM C 8.

Stampa la pagina

Bristan Blade Bath Shower Mixer BL BSM C Istruzioni per il montaggio ed elenco dei contenuti

Specification continued

Designed to comply with BS EN 200 for single taps/ combination

taps for water systems of type 1 and 2 general technical

specifications and to be used within systems designed to BS 6700.

BS 6700 recommends the temperature of stored water should

never exceed 65°C. A stored water temperature of

60°C is considered sufficient to meet all nominal requirements

and will minimise the build up of lime scale in hard

water areas.

4. Installation

This mixer is suitable for use at all supply pressures, however for optimum use both hot and cold supplies should

be reasonably balanced. If the fitting is installed at low pressure (tank fed), then the minimum height from the

Bath shower mixer to the underside of the cold tank should be at least 5.0 metres to ensure adequate shower

performance.

This mixer should be installed in compliance with Water Regulations. For further details please contact your local

Water Authority.

Where the supplies are unbalanced i. e. hot water from the cylinder tank and cold from the mains, approved

check valves must be fitted in the supply pipes.

1. Identify all components are present prior to installation.

2. Fit the mixer body (1) to the bath and secure using the rubber washers (2) and backnuts (3) below the bath.

Connect the hot and cold water supplies.

3. Fit the hose (4) to the mixer (1) and the handset (9) using the small sealing washers (5). To adjust the hose

outlet position, loosen screw (f) then rotate the hose outlet to desired position. Secure in place with grub screw

(f).

4. Fix the wall bracket (8) to the wall using screw (7) and wall plug provided, ensuring the handset will reach it.

Attach the bracket handset holder (6).

5. Fully open both valves letting the water run for a few minutes to flush the system and check joints and

connections for leaks.

6. Operate the mixer in both bath and shower mode. To switch from bath fill to shower mode simply pull the

diverter knob (e) up. After use the mixer automatically reverts back to bath filling mode.