Decagon Devices GS3 Manuale - Pagina 10

Sfoglia online o scarica il pdf Manuale per Accessories Decagon Devices GS3. Decagon Devices GS3 12. Greenhouse sensor

GS3 Integrator Guide

R34

DDI-SERIAL COMMUNICATION

The DDI-Serial communications protocol is ideal for systems that have dedicated serial signaling lines for

each sensor or use a multiplexer to handle multiple sensors. The serial communications are compatible

with many TTL serial implementations that support active-high logic levels using 0-3.6 volts signal levels.

When the sensor is first powered, it automatically makes measurements of the integrated transducers

then outputs a response over the data line. Systems using this protocol control the sensor excitation to

initiate data transfers from the sensor. This protocol is subject to change as Decagon improves and

expands our line of digital sensors and data loggers.

NOTE: Out of the factory, all Decagon sensors start with SDI-12 address zero and print out the startup

string when powered cycled. On GS3 sensors with firmware version 3.37 and newer the start up string is

omitted when the address is non-zero.

DDI-SERIAL TIMING

DDI-serial communication sends characters at 1200 bits per second. Each character has 1 start bit, 8

data bits (LSB first), no parity bit, and 1 stop bit. (Active high or non-inverted logic levels)

START

STOP

Example serial transmission of the character '9' (0x39)

Upon power up, the sensor will pull the data line high within 100 mS to indicate that the sensor is taking a

reading. When the reading is complete, the sensor begins sending the serial signal out the data line.

Once the data is transmitted, the sensor goes into SDI-12 communication mode. In order to get another

serial signal, the sensor must be power cycled.

POWER

Measurement Signal

(at most 100ms)

DDI Response

SDI-12 Mode

DATA

For support contact us via email at

or call us at 1.509.332.5600 between 7AM to 5PM PST