AIRFLO PSV-8L Manuale dell'operatore e dei ricambi - Pagina 5

Sfoglia online o scarica il pdf Manuale dell'operatore e dei ricambi per Spreader AIRFLO PSV-8L. AIRFLO PSV-8L 17.

OPERATORS MANUAL – PSV-8L (ELECTRIC)

Installation Instructions

Mounting the Spreader onto the

Vehicle

1. Install the inverted "V" in the

spreader using the 3/8 - 16X 1" hex

bolts, 3/8" nuts, and 3/8" washers

provided.

2. Remove the tailgate from the

vehicle.

3. Lift the spreader by attaching the

lifting device to the slot on the

passenger side of the rear inside

brace.

CAUTION

Check the rated maximum payload of

the lifting device before lifting the

spreader.

4. Place the spreader on top of two

pieces of lumber so that the lumber

rests under the side gussets as

shown in figure 7. NOTE: This will

help to remove any excess material

that accumulates under the

spreader.

5. Place the spreader in the back of the

vehicle so that it is centered to the

vehicle and the rails of the spreader

are 14" from the rear of the truck.

6. Bolt the spreader to the vehicle

frame through side gussets and the

lumber.

7. Tie the spreader to the vehicle from

the tie-down eyes to the vehicles

anchor points.

AIR FLO MANUFACTURING., CO INC.

Bill of Materials

Figure 6.

Figure 7.

4 |

P a g e