Centrometal CentroPelet ZV14 Istruzioni tecniche - Pagina 8
Sfoglia online o scarica il pdf Istruzioni tecniche per Stufa a pellet Centrometal CentroPelet ZV14. Centrometal CentroPelet ZV14 12.
Anche per Centrometal CentroPelet ZV14: Istruzioni tecniche (12 pagine)
Stampa la pagina
Remote Control
The remote control (Pict. 3) s used to adjust water tempe-
To start the pellet boiler stove, press keys
multaneously. The pellet boiler stove will automatically en-
ter the starting phase.
Press keys
and
use keys
and
To turn off the pellet boiler stove, hold down keys
simultaneously. "OFF" will be shown on the Pellet
boiler stove display.
Pict. 3
To replace the 12 volt battery located on the back of the
Replace the battery observing the correct polarity (Pict. 4).
Pict. 4
and
to adjust water temperature, and
to adjust operating power.
S
: 12V
Size: 12V
IZE
In the event of a working defect, the system informs the
user about the type of failure occurred.
The following table summarises the alarms, kind of problem
si-
and possible solution:
Upper
Lower
display
display
and
- the pellet boiler stove
NO
cannot start up
ALAR
ACC
- this is the first light-up
- the pellet boiler stove
NO
ALAR
switched off while wor-
FIRE
king
The smokes sensor is
SOND
ALAR
broken or not connected
FUMI
to the pcb
The water temperature
exceeds 90°C. The cir-
HOT
culating pump is blocked
ALAR
H20
or there is no water in the
hydraulic system
The water sensor is not
SOND
connected
ALAR
There is a short circuit on
H20
the water sensor
HOT
The smokes temperature
ALAR
TEMP
exceeds 280°C
COOL
FIRE
There is no power sup-
ply
FAN
Smokes extractor blo-
ALAR
cked or broken
FAIL
Obstructed flue
DEP
ALAR
FAIL
Pellets tank overheating
SIC
ALAR
FAIL
Too high water tempera-
SIC
ALAR
ture
FAIL
The system pressure
does not reach 0,5 bar
ALAR PRESS
or exceeds 2,3 bar
The stove has worked
for 1300 hours.
Supplementary
SERV
maintenance required
Regular checks should be carried out by the user, who
should only contact the Technical Assistance Service if
no solution is found.
Kind of failure
Fill in the tank with pellets
Start up again
Fill in the tank with pellets
Contact an authorised and
qualified
stance
Check the power supply
on the pump.
Check limestone does not
block the pump impeller
Check the water sensor is
connected
Contact an authorised qua-
lified technical assistance
Smokes sensor failure
Contact an authorised qua-
lified technical assistance
As soon as the power sup-
ply is back, the stove starts
a cooling cycle. After com-
pleting the cycle it starts
working automatically
Contact
qualified technical assi-
stance
Clean the flue or check
there are no obstructed
grids near the smokes
exhaust
Re-set the safety thermostat
for pellets on the back of the
stove. If the problem occurs
again, contact an authorised
qualified technical assistance
Re-set the safety thermostat
for water on the back of the
stove. If the problem occurs
again, contact an authorised
qualified technical assistance
Reduce the system
pressure
Charge the system
Contact an authorised
qualified technical assi-
stance
Solution
technical assi-
an
authorised