Gamma Progression 600 Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Macchine incordatrici Gamma Progression 600. Gamma Progression 600 15.

Your GAMMA 600 stringing machine is adjusted for optimum performance at the factory and

needs no further adjustments before use. After extensive use however, the machine may

need minor adjusments as follows :

damages the string, it is too tight and must be adjusted by turning the thumb knob or hex screw

counterclockwise.

The clamp jaws must be clean and free from dirt, oil, and any string coating for them to grip

properly. Clean the clamp jaws with alcohol.

Note: The string clamps supplied with your Gamma stringing machine can accomodate

tight string patterns such as badminton. Depending on the string pattern, the clamp

will spread the strings slightly which will not compromise the quality of the string

job.

MAINTENANCE

Adjusting the Turntable Bushings

There are two adjustment points on the

machine base. One is located beneath the

polystyrene base cover while the other is

accessed from below the machine.

Using the supplied 3mm hex wrench, tighten

both set screws slightly until the turntable

rotates smoothly without excessive free

play.

Repeat procedure until final adjustment is

reached.

Adjusting the Clamps

The clamps provided with your stringing

machine will need minor adjustments ac-

cording to what string type, construction,

and gauge you are using.

To adjust, route the string through the racquet

as if you were beginning the main strings.

Clamp the strings and pull tension. If the

string slips through the jaws of the clamp,

tighten the clamp by turning the thumb knob

(floating clamp) or hex screw (fixed clamp)

opposite of the handle, in the clockwise

direction. If the clamp leaves impressions or