Decibel Eleven Time After Time Manuale operativo - Pagina 3
Sfoglia online o scarica il pdf Manuale operativo per Pedale musicale Decibel Eleven Time After Time. Decibel Eleven Time After Time 13. Fully analog delay pedal
Stampa la paginaCONNECTIONS
Input and Output
Connect your instrument to the input and connect the output to the amplifier.
Power
The Time After Time can be powered from any regulated 9VDC power supply capable of
providing a minimum of 75mA. The rear panel POWER jack is a standard 2.1mm DC
power jack, center negative connection.
MIDI
Connect the MIDI IN of the Time After Time to the MIDI OUT of your MIDI controller, or
to the MIDI OUT of the last device in the MIDI chain. Additional MIDI devices can be
connected from the MIDI THRU of the Time After Time.
QUICK START
FOOTSWITCH OPERATION
In its default mode, the Time After Time 'A' footswitch is used to scroll through the
available presets, while the 'B' footswitch is used to enable or bypass the effect. For
other operating modes, see OPERATING MODES on page 6.
PRESETS
The Time After Time uses presets to save and recall settings. A preset consists of all of
the knob settings, including delay time, feedback level, modulation depth, modulation
rate, mix level, and TAP mode setting.
Because the Time After Time is preset based, there are some differences between its
operation and the operation of typical effect pedals. When the Time After Time gets
enabled, it loads a preset from its memory. It does not immediately load the current
settings of the knobs as you see them. The loaded preset settings may be completely
different than the current knob settings.
Once the pedal is enabled, turning a control knob will not modify its parameter until the
knob becomes aligned with the same setting as that of the loaded preset. Once a knob
has been aligned with the preset setting, it becomes "engaged", at which point it will
function as an active knob.
As you turn the knobs, you may see the display change to a horizontal line. These lines
can be used to locate the positions of knobs as they are saved in the current preset.
3