Gamma Torrent Wash IP Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di illuminazione Gamma Torrent Wash IP. Gamma Torrent Wash IP 16. 480w ip65 led wash light

Stampa la pagina

Multiple sets of 512 "universes" may be used. Only 1 universe will travel on a DMX cable,

but through networked DMX (Art-Net or sACN E1.31), many universes can travel over a

network.

DMX Wiring

DMX works by connecting 1 or multiple lights to the output of a DMX lighting console or

software with a DMX interface.

DMX lights connect in what is called a "daisy-chain". Your first DMX cable will plug it's

male DMX connector into the female DMX connector on your lighting console. The

remaining female connector will then connect to the DMX input on your first light.

You may then connect your next fixture to the output of your first light, and continue the

chain.

32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy

chain for signal strength. Sometimes, depending on the fixtures and cable length, this

number is less (or more).

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin

only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at

least 110 ohms resistance. Microphone cable is not DMX cable.

Please refer to the diagram below:

For installations where the DMX cable has to run a long distance or is in an electrically

noisy environment, it is recommended to use a DMX terminator. This helps in preventing

corruption of the digital control signal by electrical noise and reflections. The DMX

terminator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and 3,

which is then plugged into the output XLR socket of the last fixture in the chain. Please

see illustrations below:

GAMMA LED Vision – Torrent Wash IP

Page 8 of 16