JAKO RD101CP Manuale di installazione
Sfoglia online o scarica il pdf Manuale di installazione per Per serrature JAKO RD101CP. JAKO RD101CP 2.
Stampa la paginaDEADBOLTS
DEADBOLT LOCK KEY-THUMBTURN
Cod.RD101CP / RD101CP-AS / SD01CP
Installation guide
TOOLS REQUIRED FOR REMODELING OR
NEW CONSTRUCTION:
1 philips head screwdriver
1 2" hole saw
1 1" drill
1 chisel
TOOLS REQUIRED FOR REPLACEMENT:
1 philips head screwdriver
FOLLOW STEPS 6,7,8,9,10 FOR DO IT YOURSELF
REPLACEMENT, FOLLOWING REMOVAL OF EXISTING LOCK.
1. MARKDOOR
A. Fold and apply template to high
edge of door bevel and mark
center of door edge as indicated
on template at the desired
height from the oor.
3. INSTALL LATCH
A. Insert latch in hole, keeping
B. Chisel 1/8" deep or until latch
it parallel to face of door.
face is ush with door edge.
Mark outline and remove
latch.
B. Mark center hole on door face
through guide on template. For
either 2 3/8" , 2 3/4" bakset..
B. Install deadbolt latch in
"up" position into hole
as shown on latch.
Insert and tighten
screws.
www.jakohardware.com
INSTRUCTION FOR ADJUSTABLE DEADBOLT
PRIMARY SLOT
SECONDARY SLOT
60mm (2-3/8")
70mm (2-3/4")
2. DRILL HOLES
A. Drill thru door face as marked
for lockset: It is recommended
that holes be drilled from both
sides to prevent splitting. Hole
size is 2" for standard installations.
4. INSTALL STRIKE
A. Close door against door stop.
Insert edge of template
against the at side of latch
bolt, and mark template at
edge of door, jamb to locate
strike opening. Move 3/8"
toward door stop to locate
center line for screws and 1"
hole. This will insure the
proper location of the strike.
Unscaled format
TO CHANGE 2-3/8" TO 2-3/4"
Thumb press the end of the latch,
with the Adjustable Slot facing toward yourself,
turn the body of the latch clockwise and
make sure that THE PIN DROP INTO THE SECONDARY
SLOT, THEN PULL TO THE SIDE. Twist the body of the
latch counter clock wise TILL THE PIN DROP INTO THE
UPPER PRIMARY SLOT.
B. Drill 1" hole in center of door
edge thru to 2" hole for latch
B. Chisel 1/16"
deep for strike
matching 1"
hole in door
jamb. Insert
and tighten
screws.