DECKED TOOL BOX Installazione

Sfoglia online o scarica il pdf Installazione per Automobile Accessories DECKED TOOL BOX. DECKED TOOL BOX 2.

STEP 1:

Place rubber pads on bed rails.

(1) per side.

PLACE RUBBER PAD OVER

INSIDE LEDGE OF BED RAIL

STEP 3:

Open the Tool Box lid to be sure it doesn't hit the cab of truck

under any circumstances. Make sure there is adequate

distance between the lid and any cab mounted cameras,

lights or other important bits.

Shift the Tool Box toward the tailgate as needed.

STEP 4:

Install (2) bed rail clamps on each side of the Tool Box using one location as close to the tailgate as possible and one location

as close to the cab as possible. NOTE: Outermost clamp locations vary per vehicle depending on the topology of the bed rails.

Secure clamps with bolts, washers and nuts in order shown. Tighten all four bolts.

Test tightness by closing Tool Box lid and pulling on the handles, L-R and front to back.

Tool Box should not move on the bed rails.

DECKED.COM | 208-806-0251

TOOL BOX INSTALLATION

(2) BOLTS, (2) WASHERS PER SIDE

(OUTERMOST HOLE LOCATIONS

VARY DEPENDING ON VEHICLE)

STEP 2:

Unless you've experienced radiation exposure (allowing

you to mutate into The Hulk) grab a friend to help you lift

the Tool Box into place on top of the rubber pads. Center

the Tool Box L-R between the bed rails and align square

to the bed on both sides.

TEAM LIFT

REQUIRED

REQUIRED:

slide

(2) CLAMPS, (2) NUTS PER SIDE

(OUTERMOST HOLE LOCATIONS

VARY DEPENDING ON VEHICLE)

TOOLS NEEDED:

• 3/8" socket

• Ratchet

WARNING

SHIFT TOOL BOX

AS NEEDED FOR

CAB CLEARANCE

TBFDL | v.1 | Page 1