Major tech MT476 Manuale di istruzioni - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per Multimetro Major tech MT476. Major tech MT476 16. 690v voltage tester

10. CONTINUITY CHECK

The voltage tester can also be used as a continuity tester. Always hold the

voltage tester by the handles designed for this purpose. Never touch the

device beyond the handle ends. The continuity tester switches itself on

automatically when the test starts, and switches itself back off when the

test has been completed. Check for correct functioning before beginning

the test. If you connect the two test tips with each other, you should heap

a beep, and the continuity LED should light up. If this is not the case,

replace the batteries as described under "Inserting/Changing the Batteries".

The continuity tester indicates resistances of up to<400 k Ohm.

11. USING THE VOLTAGE TESTER AS A " SINGLE-POLE" PHASE

TESTER

The Voltage tester can also be used as a "single-pole" phase tester. Always

hold the voltage tester by the handles designed for this purpose (3 and 6).

Never touch the device beyond the handle ends.

This "phase test" serves as a quick test only. Please check again for zero

potential with the twin-pole measuring method before you do any work

on this circuit. Observe the regulations regarding work with electrical

systems.

Before beginning the test, check the condition of the batteries by

connecting the two test tips with each other.

Check for correct functioning at a known alternating voltage source.

Contact test tip "L2" with the measuring point to be tested. In the event

of the phase (alternating current between 100 and 690V), the lightening

symbol LED lights up.

The "single-pole" phase display can be adversely affected by

unfavourable ambient conditions (electrostatic fields, good insulation

etc.). In all cases, conduct an additional, twin-pole voltage test.

10 12